Dlp-H53 Provision Line Dcc Terminations - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H53 Provision Line DCC Terminations

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
When MS-DCC is provisioned, an RS-DCC termination is allowed on the same port, but is not
Note
recommended. Using RS-DCC and MS-DCC on the same port is only needed during a software upgrade
if the software version does not support MS-DCC. You can provision RS-DCCs and MS-DCCs on
different ports in the same node.
Step 1 In node view click the Provisioning > Comm Channels > MS-DCC tabs.
Click Create.
Step 2
In the Create MS-DCC Terminations dialog box, click the ports where you want to create the DCC
Step 3
termination. To select more than one port, press the Shift key or the Ctrl key.
Note
In the Port Admin State area, click the Set to unlocked radio button.
Step 4
Verify that the Disable OSPF on Link check box is unchecked.
Step 5
Step 6 If the MS-DCC termination is to include a non-ONS node, check the Far End is Foreign check box.
This automatically sets the far-end node IP address to 0.0.0.0, which means that any address can be
specified by the far end.
In the Layer 3 box, perform one of the following:
Step 7
•
•
If you checked OSI, complete the following steps. If you checked IP only, continue with
Step 8
a.
b.
78-19416-01
This task creates the Line Data Communications Channel (MS-DCC)
terminations required for alarms, administration, data, signal control
information, and messages.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
MS-DCC refers to the Line DCC, which is used for ONS node DCC terminations. The SDH Line
DCCs and the Section DCC (when not used as a DCC termination by the ONS node) can be
provisioned as DCC tunnels. See the
Check the IP box only—if the MS-DCC is between the ONS 15310-MA SDH and another ONS node
and only ONS nodes reside on the network. The MS-DCC will use PPP (point-to-point protocol).
Check the IP and OSI boxes—if the MS-DCC is between the ONS 15310-MA SDH and another
ONS node and third party NEs that use the OSI protocol stack are on the same network. The
MS-DCC will use PPP.
OSI-only (LAP-D) is not available for MS-DCCs.
Note
Click Next.
Provision the following fields:
Router—Choose the OSI router
–
"DLP-H67 Create a DCC Tunnel" task on page
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-84.
Step 9.
16-71