Ntp-B194 Create Overhead Circuits - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 5
Create Circuits and VT Tunnels
At the source node connect an Ethernet test set to the source port and configure the test set to send and
Step 8
receive the appropriate Ethernet traffic.
Transmit Ethernet frames between both test sets. If you cannot transmit and receive Ethernet traffic
Step 9
between the nodes, repeat Steps
correctly.
Perform the protection switch that is appropriate to the SONET topology:
Step 10
•
•
Configure your test set according to local site practice. For information about configuring your test set,
see your test set user guide.
Change the circuit and circuit ports to the IS service state:
Step 11
a.
b.
c.
d.
e.
f.
After the circuit test is complete, print the results or save them to a disk for future reference. For
Step 12
information about printing or saving test results see your test set user guide.
Stop. You have completed this procedure.
NTP-B194 Create Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the overhead circuit. If you are already logged in, continue with Step 2.
From the View menu choose Go to Network View.
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
Stop. You have completed this procedure.
March 2003
For path protection, see the
For BLSRs see the
"DLP-B91 BLSR Ring Switch Test" task on page
Click the Circuits tab.
Choose the circuit you want to test.
From the Tools menu choose Circuits > Change Circuit State.
In the Change Circuit State dialog box, choose IS from the Target Circuit State drop-down menu.
Check the Apply to circuit drops check box.
Click OK.
This procedure creates overhead circuits on an ONS 15327 network.
Overhead circuits include DCC tunnels, orderwire, and user data channels.
None
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B313 Create a DCC Tunnel" task on page
"DLP-B212 Create a User Data Channel" task on page
1
through
6
to make sure you configured the Ethernet ports and test set
"DLP-B94 Path Protection Switching Test" task on page
NTP-B194 Create Overhead Circuits
4-20.
at a node on the network where you will
5-80.
5-81.
Cisco ONS 15327 Procedure Guide, R4.0
4-26.
5-79
Advertisement
Table of Contents
