Ntp-B170 Create Optical Protection Groups - Cisco ONS 15327 Procedure Manual

NTP-B170 Create Optical Protection Groups

•
Reference Lists
•
Step 9 Click Apply.
Repeat Steps
Step 10
Return to your originating procedure (NTP).
Step 11
NTP-B170 Create Optical Protection Groups
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
A 1:1 (electrical) protection group is preprovisioned on the ONS 15327 XTC card. The name of the
Note
protection group is XTCPROTGRP, and it cannot be edited or deleted. Therefore, you only need to create
protection for optical cards.
Complete the
Step 1
protection group. If you are already logged in, continue with
From node view, click the Provisioning > Protection tabs.
Step 2
Under Protection Groups, click Create.
Step 3
Step 4 In the Create Protection Group dialog box, enter the following:
•
•
•
•
From the Available Ports list, choose the port that will be protected by the port you selected in Protect
Step 5
Ports. Click the top arrow button to move each port to the Working Ports list.
Cisco ONS 15327 Procedure Guide, R4.0
3-20
Timing Mode—Set to Line
NE Reference
Ref 1—Set to the OC-N trunk card with the closest connection to the node in
–
Ref 2—Set to the OC-N trunk card with the next closest connection to the node in
–
– Ref 3—Set to Internal Clock
6 through 9 at each node that will be timed by the node in
This procedure creates ONS 15327 card protection groups.
None
NTP-B24 Verify Card Installation, page 3-2
Required; some network information is optional, depending on your site
plan
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
Name—Type a name for the protection group. The name can have up to 32 alphanumeric characters.
Type—Choose 1+1 from the pull-down menu.
Protect Port—Choose the protect port from the pull-down menu. The menu displays the available
OC-N ports. If OC-N cards are not installed, no ports display in the pull-down menu.
After you choose the protect port, a list of ports available for protection is displayed under Available
Ports. If no cards are available, no ports are displayed. If this occurs, you will not be able to complete
this task until you install the physical cards or preprovision the ONS 15327 slots.
Chapter 3
Step 3.
at the node where you want to create the
Step 2.
Turn Up Node
Step 3
Step 3
March 2003