Dlp-B323 Install The Serial Cable For Tl1 Craft Interface; Table 1-4 External Timing Pin Assignments For Bits - Cisco ONS 15327 Procedure Manual

NTP-B8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections
Table 1-4
External Device
First external device
Second external device A1 (BITS 2 Out)
Note
Return to your originating procedure (NTP).
Step 4

DLP-B323 Install the Serial Cable for TL1 Craft Interface

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Plug one end of the serial cable into the front of the XTC card.
Step 1
Connect the other end to the PC you want to use to access the craft.
Step 2
Note
Return to your originating procedure (NTP).
Step 3
Cisco ONS 15327 Procedure Guide, R4.0
1-32
External Timing Pin Assignments for BITS
Contact
A3 (BITS 1 Out)
B3 (BITS 1 Out)
A4 (BITS 1 In)
B4 (BITS 1 In)
B1 (BITS 2 Out)
A2 (BITS 2 In)
B2 (BITS 2 In
For more detailed information about timing, refer to the Cisco ONS 15327 Reference Manual.
To set up system timing, see the
This task installs the TL1 craft interface.
Serial cable (DB-9)
NTP-B2 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
You can connect to either the active or standby XTC DB-9 plug to gain terminal access, but not
both simultaneously.
Tip & Ring
Primary ring (-)
Primary tip (+)
Secondary ring (-)
Secondary tip (+)
Primary ring (-)
Primary tip (+)
Secondary ring (-)
Secondary tip (+)
"NTP-B28 Set Up Timing" procedure on page
Chapter 1 Install Hardware
Function
Output to external device
Output to external device
Input from external
device
Input from external
device
Output to external device
Output to external device
Input from external
device
Input from external
device
3-16.
March 2003