Install Cisco Catalyst Network Interface Module; Overview Of The Network Interface Module - Cisco Catalyst 8300 Series Hardware Installation Manual

Install Cisco Catalyst Network Interface Module

This section provides information before and during the installation of Cisco Catalyst Network Interface
Modules (NIMs) on the Cisco Catalyst 8300 Series Edge Platforms.
•
•
•
•
•

Overview of the Network Interface Module

The Cisco Catalyst Network Interface Module (NIM), which has 10G WAN and 1xSFP+ 10G port is supported
on Cisco Catalyst 8300 Series Edge Platforms.
For additional information, see the Cisco Catalyst 8300 Series Edge Platforms
list of supported NIMs on the platforms.
Figure shows the front panel of the Catalyst Network Interface Module
Overview of the Network Interface Module, on page 97
, on page 97
Remove and Install Network Interface Modules, on page 98
Remove and Install Network Interface Modules Adapter, on page 99
Install Network Interface Modules in the NIM Adapter, on page 102
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
5
C H A P T E R
datasheet on cisco.com for a
97