Configuring Controller And Interface Parameters; Configuring Controller Parameters; Configuring Fast Ethernet And Serial Interface Parameters; Serial Interface - Cisco 2431 - IAD Router Software Configuration Manual

Chapter 2 Using the setup Command Facility
Note

Configuring Controller and Interface Parameters

From this point on in the setup process, the prompts you see vary, depending on the interface cards
installed in your Cisco IAD.
The Cisco IAD2435 router is a fixed-configuration router and does not support interface cards.
Note
The following sections provide examples of the setup steps for cards. See the sections appropriate to
your Cisco IAD.
Configuration examples include the following:
•
•
•
When you complete the setup steps for your interface modules, go to the
Configuration" section on page 2-13

Configuring Controller Parameters

Controllers can be either built in or on an interface module.
Configuring controller parameters. Controllers are hardware on the router
that you connect directly to a T1 or E1 line from your Telco. Configure
controllers for such purposes as Primary Rate ISDN(PRI) and/or
Channelized T1 or Channelized E1.
Note: J1 controllers are not configurable in setup mode.
Configuring controller T1 1/0 in pri or channelized mode
Do you want to configure this controller ? [yes]: no

Configuring Fast Ethernet and Serial Interface Parameters

This section provides examples for the following:
•
•
OL-4306-03
If you answer no to Interior Gateway Routing Protocol (IGRP), you are prompted to configure
Routing Information Protocol (RIP).
Configuring Controller Parameters, page 2-5
Configuring Fast Ethernet and Serial Interface Parameters, page 2-5
Configuring a 1-Port, 4-Wire 56-kbps DSU/CSU Card, page 2-11
Fast Ethernet WAN Interface Configuration
Serial Interface Configuration
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Configuring Controller and Interface Parameters
for directions on saving your configuration.
"Completing the
2-5