Path-Option - Cisco NCS 1004 Command Reference Manual

Commands

path-option

To specify a path option for a GMPLS UNI tunnel, use the path-option command in GMPLS UNI controller
tunnel-properties configuration sub-mode.
path-option 10 { no-ero | explicit { name path-name | index index } } [ xro-attribute-set name ] [lockdown]
[verbatim]
Syntax Description
10
explicit
name
path-name
no-ero
xro-attribute-set
name
lockdown
verbatim
None
Command Default
GMPLS UNI controller tunnel-properties configuration
Command Modes
Command History
Release
Release
7.0.1
Example
The following example shows how to specify the tunnel path option for controller 0/0/0/0, attribute
set A01..
RP/0/RP0/CPU0:ios(config)#mpls traffic-eng
RP/0/RP0/CPU0:ios(config-mpls-te)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-te-gmpls)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-te-gmpls-cntl)#tunnel-properties
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#path-option 10 no-ero xro-attribute-set A01 lockdown
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#
Specifies the path option index. 10 is the only supported index
Specifies that LSP paths are IP explicit paths.
Specifies the path name of the IP explicit path.
Specifies that no ERO object is included in signalling.
(Optional) Specifies the xro attribute set for the path option.
Specifies the name of the xro-attribute-set.
(Optional) Indicates that the tunnel does not reoptimize without user intervention.
(Optional) Bypasses the topology check for explicit paths.
Modification
This command is
introduced.
Command Reference for Cisco NCS 1004
path-option
55