Ntp-G117 Replace The Ansi Shelf Alarm Interface Panel - Cisco ONS 15454 M12 Maintenance Manual

NTP-G117 Replace the ANSI Shelf Alarm Interface Panel

Figure 19: Fan-Tray Extracted
Step 6 Slide the new fan-tray into the shelf assembly until the electrical plug at the rear of the tray plugs into the
corresponding receptacle on the backplane.
Step 7
To verify that the tray has plugged into the backplane, ensure that the LED on the front of the fan-tray is
activated.
If you removed the door, complete the
Stop. You have completed this procedure.
NTP-G117 Replace the ANSI Shelf Alarm Interface Panel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
26
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
NTP-G258 Install the Standard Door of the ONS 15454 M6 Shelf
This procedure replaces the AIP on the ONS 15454 ANSI shelf assembly.
#2 Phillips screwdriver
None
As needed
Onsite or remote
Provisioning or higher
.