Cabling the Line Ports and Completing the
Installation
This chapter provides instructions for cabling the Gigabit Ethernet ports and for configuring
Gigabit Ethernet (GBE) interface parameters.
When installing an External Optical Bypass module, the SCE 1000 line ports are connected to the
Note
module. See
This chapter contains the following sections:
•
Connecting the line ports to the network 6-1
•
Loading and Activating a Service Control Application
Connecting the line ports to the network
The procedures for cabling the line ports, configuring the interface parameters, and testing
connectivity of the links are explained in the following sections:
Cabling Diagrams
•
Configuring the GBE Interface Parameters
•
•
Connecting the GBE Line Interface Ports
Testing Connectivity: Examining Link LEDs, GBE Counters ("Testing Connectivity:
•
Examining Link LEDs and
Cabling Diagrams
Before beginning, find the appropriate cabling diagram for the topology in your installation:
Single SCE 1000 topologies
•
OL-7821-04
Cabling the External Optical Bypass Module
(on page 6-1)
•
Single Link: Inline Topology
Single Link: Receive-only Topology
•
(on page A-4) for complete instructions.
(on page 6-3)
(on page 6-5)
Counters" on page 6-7)
(on page 6-2)
(on page 6-2)
Cisco SCE 1000 2xGBE Installation and Configuration Guide
C H A P T E R 6
6-8
6-1