Installing A Dual In-Line Memory Module (Dimm) - Cisco Catalyst 8300 Series Hardware Installation Manual

Installing a Dual In-line Memory Module (DIMM)

5. Lift the chassis cover after you have removed all the screws.
Note
•
•
•
•
•
•
•
•
Installing a Dual In-line Memory Module (DIMM)
There are four DDR4 DIMM slots. DIMMs have a polarization notch on the connecting edge to prevent
incorrect orientation of the module during insertion.
Figure 1. DIMM Showing Polarization Notch
1
These are the steps to install a DIMM:
1. Remove the chassis cover.
2. Locate the DIMM slots on the device. There are four DIMM slots in the chassis and you can install the
DIMM module on any of the slots.
3. Make sure that both latches on the DIMM connector are in the open position.
Figure 2. DIMM orientation
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
30
To replace the chassis cover, place the cover evenly on the top of the device and use the screws to secure it
to the device.
Installing a Dual In-line Memory Module (DIMM), on page 30
Removing a DIMM, on page 31
Installing the M.2 Storage Module, on page 31
Installing and Removing a Network Interface Module (NIM), on page 33
Installing Pluggable Interface Module, on page 34
Installing Drive Bays, on page 35
Replace (Remove and Install) Fan Tray, on page 37
Remove Small Form Pluggable Modules, on page 38
Install and Upgrade Field Replaceable Units
Polarization Notch