Advertisement
Installing the Cisco NCS 2000 Series Passive Optical Modules
Figure 38: Installing the Rack Mounting Bracket on an ETSI Equipment Rack
Step 3
Insert the screws along with the lock washers and tighten them.
Install the Optical Module
This procedure explains how to install the optical module into the rack mounting bracket.
Procedure
Step 1
Install the rack mounting bracket on the equipment rack by following the steps described in the
Rack Mounting Bracket, on page
Step 2
Identify the slot in the rack mounting bracket to install the optical module.
Note
Step 3
Loosen the captive screws to remove the filler panel from the rack mounting bracket (see the following figure).
• Insert the M6 screws along with the lock washers for M6 screws and tighten them.
• Align the extended rack mounting bracket screw holes against the equipment rack screw holes (see
the following figure).
39.
The rack mounting bracket has two cut outs. Each cut out (left or right) can accommodate two single
slot cassettes, for a total of four single slot cassettes in the rack mounting bracket. Each cut out (left
or right) can also accommodate one double slot cassette, for a total of two double slot cassettes in
the rack mounting bracket. If a rack mounting bracket slot remains empty, it can be filled with a
blank-slot filler panels.
Installing the Cisco NCS 2000 Series Passive Optical Modules
Install the Optical Module
Install the
41
Advertisement
