Install And Upgrade Field Replaceable Units - Cisco Catalyst 8300 Series Hardware Installation Manual

4
C H A P T E R

Install and Upgrade Field Replaceable Units

These are the steps to remove the chassis cover:
Removing and Replacing the Chassis Cover
Figure 21: Removing and Replacing the chassis cover
1. Confirm that the chassis is turned off and disconnected from the power supply or power supplies.
2. Place the chassis on a flat surface.
3. Remove the screws from the top of the chassis cover.
4. Remove screws from each side and from the top of the device as shown in the figure.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
31