Install And Upgrade Field Replaceable Units - Cisco Catalyst 8300 Series Hardware Installation Manual

4
C H A P T E R

Install and Upgrade Field Replaceable Units

Removing and Replacing the Chassis Cover
Figure 1. Removing and Replacing the chassis cover
These are the steps to remove the chassis cover:
1. Confirm that the chassis is turned off and disconnected from the power supply or power supplies.
2. Place the chassis on a flat surface.
3. Remove the screws at top of the chassis cover.
4. Remove screws from each side and top of the device as shown in the above figure.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
29