Dlp-B227 Disable Alarm Filtering; Ntp-B72 Suppress And Discontinue Alarm Suppression - Cisco ONS 15327 Procedure Manual

NTP-B72 Suppress and Discontinue Alarm Suppression

DLP-B227 Disable Alarm Filtering

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 At the node, network, or card view, click the Alarms tab.
Click the Filter tool at the lower-right side of the bottom toolbar.
Step 2
Alarm filtering is enabled if the tool is selected and disabled if the tool is raised (not selected).
If you want alarm filtering disabled when you view conditions, click the Conditions tab and repeat
Step 3
Step
If you want alarm filtering disabled when you view alarm history, click the History tab and repeat
Step 4
Step
Return to your originating procedure (NTP).
Step 5
NTP-B72 Suppress and Discontinue Alarm Suppression
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
Step 2 Complete the
autonomous messages that clear particular raised alarms and cause the suppressed alarms to appear in
the Conditions window.
Cisco ONS 15327 Procedure Guide, R4.0
6-30
Use this task to turn off specialized alarm filtering in all network nodes so
that all severities are reported in CTC.
None
DLP-B225 Enable Alarm Filtering, page 6-27
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
2.
2.
Use this procedure to prevent alarms from being reported for a port, card,
or node in circumstances when an alarm or condition is known to exist but
you do not want to include in the display. Also use this procedure to resume
normal alarm reporting by discontinuing the suppression.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page
2.
"DLP-B119 Suppress Alarm Reporting" task on page 6-31
Chapter 6
2-23. If you are already logged in, proceed to
to make the node send out
Manage Alarms
November 2004