Verify Or Create Node Dcc Terminations; Set The Optical Power Received Nominal Value - Cisco ONS 15600 SDH Troubleshooting Manual

Chapter 2 Alarm Troubleshooting
You do not need to make any changes to the database if you are replacing it with a card of exactly the
Note
same type.
Card removal raises an MPROPRMVL alarm, but this clears after the card replacement is completed.
Note
Unlatch the bail clasp by moving it to the left before removing the bad SFP (PPM) from the slot.
Step 1
Slide the SFP (PPM) out of the slot.
Step 2
Verify that the new SFP (PPM) is correct for your network and ASAP card. Refer to the
Step 3
Cisco ONS 15600 SDH Reference Manual for more information.
Orient the new SFP so that the Cisco serial number label is facing away from the shelf (to the right).
Step 4
Slide the SFP into the slot and move the bail clasp to the right to secure the SFP.
Step 5
Do not remove the protective caps until you are ready to attach the network fiber-optic cable.
Caution
Note

2.8.5 Verify or Create Node DCC Terminations

Step 1 In node view, click the Provisioning > Comm Channels > RS-DCC tabs (or Provisioning >
Comm Channels > MS-DCC tabs as appropriate).
Step 2 View the Port column entries to see where terminations are present for a node. If terminations are
missing, proceed to
If necessary, create a DCC termination by completing the following steps:
Step 3
a.
b.
c.
d.
e.

Set the Optical Power Received Nominal Value

Step 1 In node view, double-click the STM-N card that you want to provision. The card view appears.
July 2010
Multirate SFPs (PPMs) must be provisioned in CTC; single-rate SFPs (PPMs) do not need to be
provisioned. Refer to the "Install Cards and Fiber-Optic Cable" chapter in the
Cisco ONS 15600 SDH Procedure Guide for provisioning instructions.
Step 3.
Click Create.
In the Create RS-DCC Terminations dialog box, click the ports where you want to create the DCC
termination. To select more than one port, press the Shift key.
In the Port State area, click the Set to Unlocked radio button.
Verify that the Disable OSPF on Link check box is unchecked.
Click OK.
2.8.5 Verify or Create Node DCC Terminations
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-139