Ntp-B223 Install The Fiber-Optic Cable Storage Drawer - Cisco ONS 15327 Procedure Manual

NTP-B223 Install the Fiber-Optic Cable Storage Drawer

NTP-B223 Install the Fiber-Optic Cable Storage Drawer
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
A single cable storage drawer can hold slack cable from up to two ONS 15327s.
Note
Step 1 Align the mounting holes on the bracket with the mounting holes in the equipment rack located 2 RUs
below the lowest piece of installed equipment (ONS 15327 or tie-down bar).
Note
Step 2 Install the four 12-24 or 10-32 screws through the elongated holes in the brackets and into the threaded
holes in the mounting posts.
Step 3 Stop. You have completed this procedure.
NTP-B224 Route Cables Through the Fiber-Optic Cable Storage
Drawer
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Open the cable storage drawer by pushing in the tabs to release the locked drawer
Step 1
Cisco ONS 15327 Procedure Guide, R4.0
D-2
This procedure installs the fiber-optic cable storage drawer used to store up
to 5 feet of slack optical cable from the ONS 15327.
Fiber-optic cable storage drawer
Screws, 12-24 or 10-32 (4)
DLP-B5 Mount the ONS 15327 in a Rack, page 1-8
As needed to store extra fiber cable
Onsite
None
If you are using a tie-down bar to manage cables, you must install the cable storage drawer under
the bar.
This procedure routes excess cable through the cable storage drawer.
None
NTP-B223 Install the Fiber-Optic Cable Storage Drawer, page D-2
As needed to route and store extra fiber cable
Onsite
None
Appendix D Alternate Installation Procedures
(Figure D-1).
March 2003