Fiber Optic Cable Installation - Cisco GS7000 Installation And Operation Manual

Installation
Important
4 Secure the node housing to the pedestal bracket using the strand clamp bracket bolts you removed in step
2. Insert the bolts into the mounting holes. Use the strand clamps as spacers if necessary. Torque the bolts
from 8 ft-lb to 10 ft-lb (10.8 Nm to 13.6 Nm).
5 Connect the coaxial cable to the pin connector according to connector manufacturer's specifications.
6 Ground the equipment in accordance with local codes and regulations.
7 Continue to

Fiber Optic Cable Installation

The node can accept a fiber optic cable connector from either the right or left side of the housing, or both.
The fiber optic cable(s) carries forward and reverse optical signals.
This procedure assumes a specific type of connector as an example. Your connector may be different from
the one shown in these illustrations. Be sure to install the connector according to the connector manufacturer's
instructions.
The node housing must be mounted horizontally, as shown, to ensure proper airflow over the housing
cooling fins. Do NOT mount the node housing vertically.
Fiber Optic Cable Installation, on page 21
Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide

Fiber Optic Cable Installation

and RF Cable Installation, on page 27.
21