Dlp-B126 Monitor Near-End Pm Counts; Dlp-B127 Monitor Far-End Pm Counts - Cisco ONS 15327 Procedure Manual

NTP-B195 Monitor Electrical or Optical Performance

DLP-B126 Monitor Near-End PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click an XTC card (for electrical PM counts) or OC-N card. The card view appears.
Click the Performance tab.
Step 2
Click the Near End radio button.
Step 3
Click the Refresh button. All PM parameters for the selected card on the incoming signal appear. For
Step 4
PM parameter definitions refer to the Cisco ONS 15327 Reference Manual.
View the Curr column to find PM counts for the current time interval.
Step 5
View the Prev-n columns to find PM counts for the previous time intervals.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-B127 Monitor Far-End PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click an XTC card (for electrical PM counts) or OC-N card. The card view appears.
Step 1
Click the Performance tab.
Step 2
Click the Far End radio button.
Step 3
Note
Step 4 Click the Refresh button. All PM parameters recorded by the far-end node for the selected card on the
outgoing signal appear. For PM parameter definitions refer to the Cisco ONS 15327 Reference Manual.
Step 5 View the Curr column to find PM counts for the current time interval.
Step 6 View the Prev-n columns to find PM counts for the previous time intervals.
Cisco ONS 15327 Procedure Guide, R4.0
7-10
Use this task to view near-end PM counts for the selected card and port.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
Use this task to view far-end PM parameters for the selected card and
port.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
Only cards that allow far-end performance monitoring have this button as an option.
Chapter 7 Monitor Performance
March 2003