ABB IRB 8700 Series Product Manual page 243

Removing the brake release unit
Use these procedures to remove the brake release unit.
Preparations
1
2
3
4
5
Product manual - IRB 8700
3HAC052853-001 Revision: F
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working area.
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit
please read the safety information in the section
unit is sensitive to ESD on page 32
Remove the push button guard from the SMB cover.
The push button guard must be removed to ensure
a correct refitting of the brake release unit.
Remove the SMB cover.
The battery can stay connected, to avoid needing to
synchronize the robot.
CAUTION
Carefully put the SMB cover down to avoid damaging
the battery cable connectors.
© Copyright 2015-2018 ABB. All rights reserved.
4.4.4 Replacing the brake release unit
Note
The
xx1300000743
xx1300000742
Continues on next page
4 Repair
Continued
243