Changing Oil In Axis-2 And Axis-3 Gearbox - ABB IRB 8700 Series Product Manual

3.4.3 Changing oil in axis-2 and axis-3 gearbox

Usage of oil dispenser
The oil change procedure in this section describes usage of an oil dispenser.
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx1500002014
Oil filling and draining hole, with nipple
Used with an oil dispenser.
Tightening torque: N/A
Required consumable
Material
Lubricating oil
Required tools and equipment
Equipment, etc.
Oil collecting vessel
Oil dispenser
Standard toolkit
Required documents
Document name
Technical reference manu-
al - Lubrication in gearboxes
Product manual - IRB 8700
3HAC052853-001 Revision: F
3.4.3 Changing oil in axis-2 and axis-3 gearbox
Note
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
See
Article number
-
-
-
Document number
3HAC042927-001
© Copyright 2015-2018 ABB. All rights reserved.
xx1500002013
• - Left = Inspection hole
- Right = Ventilation hole
Tightening torque: 24 Nm.
Type and amount of oil in gearboxes on page
Note
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
One example of oil dispenser can be
found in section
gearboxes on page
Content is defined in section
toolkit on page 833.
Note
Continues on next page
3 Maintenance
140.
Type of lubrication in
140.
Standard
147