Changing Oil, Axis-1 Gearbox - ABB IRB 8700 Series Product Manual

3.4.2 Changing oil, axis-1 gearbox

Usage of dispenser
The oil change procedure in this section describes usage of an oil dispenser.
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx1500002011
Top right
Bottom right
Left
Required consumable
Material
Lubricating oil
Required tools and equipment
Equipment, etc.
Oil collecting vessel
Product manual - IRB 8700
3HAC052853-001 Revision: F
Ventilation plug (can also be used for filling oil, when not
using an oil dispenser)
Inspection plug
Draining and filling (fitted with nipple intended for use of a
oil dispenser when filling or draining oil)
Note
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
See
Article number
-
© Copyright 2015-2018 ABB. All rights reserved.
3.4.2 Changing oil, axis-1 gearbox
Type and amount of oil in gearboxes on page
Note
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
Continues on next page
3 Maintenance
140.
141