Huawei SmartAX MA5603T Configuration Manual page 521

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Table 6-3 Key data plan
Confi
gurati
on
Item
MPLS
LDP
Routin
g
protoc
ol
VPLS
PW
VSI
Issue 01 (2014-04-30)
Data Remarks
l LSR ID: MPLS must be enabled at
10.10.10.10 three layers.
l VLAN: 4001 l MPLS must be enabled
l MPLS must be enabled
l MPLS must be enabled at
l MPLS LDP is MPLS LDP must be enabled
at two layers.
enabled.
l Split horizon is l MPLS LDP must be
enabled.
l MPLS LDP must be
The Open Shortest Ensure that the Layer 3
Path First (OSPF) interfaces on the MA5600T/
protocol is used. MA5603T/MA5608T and
those on SPE1 and SPE2 can
ping each other.
l PW ID: 1 and 2 L2VPN must be enabled.
l Service type: On the MA5600T/
vpls MA5603T/MA5608T, PW1
and PW2 are created for
l Encapsulation
SPE1 and SPE2 respectively.
type: ethernet
tagged
l The control
word is enabled.
l PW1 and PW2 Multicast VLAN is bound
are bound to through VSI to map VLAN to
VSI. the VPLS domain, so that
multicast service packets can
l Multicast
be broadcast in the VPLS
service VLAN
domain.
100 is bound to
VSI.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
globally.
for VLAN.
VLAN interfaces.
enabled globally.
enabled at VLAN
interfaces.
6 Configuration Example of VPLS
Requirement on SPE1
and SPE2
The LSR ID must be unique
on the entire network and
MPLS must be enabled.
MPLS LDP is enabled. The
remote LDP session to the
MA5600T/MA5603T/
MA5608T is configured on
SPE1 and SPE2.
Layer 3 interfaces and routes
are configured on SPE1 and
SPE2. Ensure that the Layer
3 interfaces and loopback
interfaces on SPE1 and SPE2
and those on the MA5600T/
MA5603T/MA5608T can
ping each other.
The LDP VPLS is supported.
VPLS PWs to the MA5600T/
MA5603T/MA5608T are
configured on SPE1 and
SPE2, and attributes of PWs
are consistent with those on
the MA5600T/MA5603T/
MA5608T.
VSI is configured on SPE1
and SPE2 and the VSI ID
must bind the corresponding
PW.
496