Configuring The Sip-Based Voice Service (Through The Cli) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

9.7.1.8 Configuring the SIP-based Voice Service (Through the CLI)

The OLT manages ONTs and applies VoIP configurations to the ONT using the OMCI protocol.
This topic describes how to configure the SIP-based voice service.
Prerequisites
l
l
Issue 01 (2014-04-30)
3. Configure the ONT VAS service.
a. On the GPON ONU tab page, select an ONT, right-click, and choose Configure
Value-Added Service from the shortcut menu.
b. Configure parameters for the SIP-based voice users.
NOTE
The parameters of the SIP-based voice user must be consistent with the corresponding
configuration on the softswitch.
a. Click the Basic Parameters tab in the dialog box that is displayed, select
Voice Service. Select User 1 and set Directory Number to 77730010.
b. Select SIP below User 1 and enter a proper value.
– Auth User Name: +8675577730010@huawei.com
– Auth Password: iadtest1
c. Set parameters of User 2 using the same method.
– Directory Number: 77730020
– Auth User Name: +8675577730020@huawei.com
– Auth Password: iadtest2
c. Click OK. The configurations take effect without the requirement of resetting
the ONT.
The SIP interface data and POTS user configuration data corresponding to the MG interface
have been configured on the SIP server.
The connection between the OLT and the SIP server is set up. The OLT can ping the IP
address of the SIP server successfully.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
611