Huawei SmartAX MA5603T Configuration Manual page 49

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
Step 3 (Optional) Set the properties of the HyperTerminal.
1.
Issue 01 (2014-04-30)
NOTE
l The baud rate of the HyperTerminal must be the same as the baud rate of the serial port on the
MA5600T/MA5603T/MA5608T. By default, the baud rate of the serial port is 9600 bit/s.
l If illegible characters are displayed on the HyperTerminal interface after you log in to the system,
it is generally because the baud rate of the HyperTerminal is different from the baud rate of the
MA5600T/MA5603T/MA5608T. In this case, set the consistent baud rate for the HyperTerminal
to log in to the system. The system supports the baud rates of 9600 bit/s, 19200 bit/s, 38400 bit/
s, 57600 bit/s, and 115200 bit/s.
Click OK to display the HyperTerminal interface.
Set the emulation type of the HyperTerminal.
Choose File > Properties on the HyperTerminal interface. In the dialog box that is
displayed, click the Settings tab, and set Emulation to VT100 or Auto Detect, as shown
in the following figure. It is Auto Detect by default.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Commissioning
24