Huawei SmartAX MA5603T Configuration Manual page 441

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
PW parameters
Tunnel
ETH service port
OSPF
PWE3 gateway
Procedure
Step 1 Configure a VLAN and add an upstream port to the VLAN.
Create upstream VLAN 200 and add upstream port 0/19/0 to VLAN 200.
huawei(config)#vlan 200 standard
huawei(config)#port vlan 200 0/19 0
Step 2 Enable MPLS.
1.
2.
3.
Issue 01 (2014-04-30)
Configure the IP address of the loopback interface.
Configure the IP address of loopback interface 0 to 5.5.5.5/32.
huawei(config)#interface loopback 0
huawei(config-if-loopback0)#ip address 5.5.5.5 32
huawei(config-if-loopback0)#quit
Configure the LSR ID of the MPLS and enable global MPLS TE and Layer 2 VPN.
huawei(config)#mpls lsr-id 5.5.5.5
huawei(config)#mpls
huawei(config-mpls)#mpls te
huawei(config-mpls)#mpls rsvp-te
huawei(config-mpls)#quit
huawei(config)#mpls l2vpn
Enable the VLAN interface MPLS TE function and configure the IP address of the VLAN
interface.
huawei(config)#mpls vlan 200
huawei(config)#interface vlanif 200
huawei(config-if-vlanif200)#ip address 192.168.1.10 24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
Data
PW ID: 10
Peer IP address: 6.6.6.6
PW type: ETH tagged
Control word: enabled
Out label: 8500
In label: 8600
Tunnel ID: 10; tunnel interface ID: 10
Encapsulation protocol of the tunnel interface at the data link
layer: MPLS TE
Tunnel signaling protocol: RSVP-TE
Port: 0/4/0
Emulation SVLAN: 3001
CVLAN: 20
OSPF process ID: 100; OSPF area ID: 1
Enable MPLS TE for the OSPF area
LSR ID: 6.6.6.6
416