Huawei SmartAX MA5603T Configuration Manual page 596

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l
l
l
NOTE
l The voice service is a closed service operated by carriers. The single-tagged S-VLAN is the mainstream
application and is recommended.
l When the planned VLAN is single-tagged VLAN, the S-VLANs can be allocated based on the OLT device,
PON board or PON port. The S-VLANs identify services and physical locations. It is recommended that
you set different voice VLANs for the OLTs connected to one voice SR to avoid an excessively large
broadcast domain of the SR and convergence switch.
l When the planned VLAN is S-VLAN+C-VLAN (that is, double-tagged VLAN), the outer S-VLANs can
be allocated based on the OLT device, PON board or PON port. The S-+VLANs identify services and
physical locations. It is recommended to allocate S-VLANs based on PON board or PON port. The inner
C-VLAN is used to identify services (a fixed value) or users.
Voice Data Plan Based on H.248 or SIP
Item
MG
interface/
SIP
interface
data
NOTE
must be
consistent
with the
data on the
MGC/IMS
core
network
devices.
Issue 01 (2014-04-30)
Double-layer VLAN S+C': C' indicates the translated inner VLAN (C'-VLAN) and S
indicates the outer VLAN (SVLAN).
Single-tagged S-VLAN: Single-tagged VLAN marked or translated by the OLT. It is
generally used in a single-tagged VLAN translation scenario.
C<->S+C': Bidirectional VLAN translation: translates the inner C-VLAN and then adds
one outer S-VLAN.
C<->S+C: Bidirectional VLAN translation: maintains the inner C-VLAN and adds one
outer S-VLAN.
Media Media and
and signaling upstream
signalin VLANs
g
Media and
paramet
signaling upstream
ers
port
Media IP
addresses and
signaling IP
addresses
Default gateway
IP address.
MG interface/SIP interface ID -
Signaling port ID
IP address of active MGC (H.
248)/IP address of active IMS
device (SIP)
Port ID of active MGC (H248)/
port ID of active IMS device
(SIP)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
Description
Upstream VLANs of the voice service
Upstream ports of the voice service
Supports separating media from signaling.
The next hop IP address from an ONU/HGW
to an MGC/IMS.
Choose the transmission mode according to
the requirement of the MGC/IMS side.
If the dual homing is not configured, only one
MGC parameter needs to be configured. If
the dual homing is configured, the IP address
and port ID of the standby MGC need to be
configured.
571