Example: Configuring The Tdm Pwe3 To Emulate Tdm Services On The Ip Network - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
mpls rsvp-te
quit
mpls l2vpn
mpls vlan 200
interface vlanif 200
ip address 192.168.1.10 24
mpls
mpls te
mpls rsvp-te
quit
ospf 1
opaque-capability enable
area 100
mpls-te enable standard-complying
network 192.168.1.0 0.0.0.255
network 5.5.5.5 0.0.0.0
return
config
interface tunnel 10
tunnel-protocol mpls te
destination 6.6.6.6
mpls te tunnel-id 10
mpls te signal-protocol rsvp-te
mpls te reserved-for-binding
mpls te commit
quit
tunnel-policy ethpw-plcy
tunnel binding destination 6.6.6.6 te tunnel 10
quit
pw-para 10
peer-address 6.6.6.6
pw-type ethernet tagged
control-word
vccv cc cw alert ttl cv lsp-ping
tnl-policy ethpw-plcy
quit
vlan 3001
service-port vlan 3001 eth 0/4/0 multi-service user-vlan 20 rx-cttr 6 tx-cttr 6
pw-ac-binding vlan 3001 pw 10 static transmit-label 8500 receive-label 8600
4.3.4 Example: Configuring the TDM PWE3 to Emulate TDM
Services on the IP Network
The MA5600T/MA5603T/MA5608T supports SAToP encapsulation for non-frame E1 signals
and implements the TDM PWE3 emulation service after IP-encapsulating the signals. In this
way, the MA5600T/MA5603T/MA5608T provides emulated TDM private line service over the
IP network.
Service Requirements
l
l
Prerequisite
l
Issue 01 (2014-04-30)
To make full use of legacy TDM line and equipment, and replace legacy DDN network
and ISDN PRI PBX convergence network.
To perform MPLS over IP encapsulation on the E1 data aggregated by the Nx64k private
line and ISDN PRI PBX, and transmit the data upstream as IP packets to the DDN network
or SDH network.
The H802EDTB board and SPUB board are installed and work in the normal state.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
419