Huawei SmartAX MA5603T Configuration Manual page 177

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
Issue 01 (2014-04-30)
huawei(config)#snmp-agent trap source vlanif 1000
7. Save the data.
huawei(config)#save
Commission the inband network management on the U2000.
1. Configure the gateway of the route from the U2000 to network segment 10.50.1.0/24
to 10.10.1.1.
– In the Solaris OS, do as follows:
Run the route add 10.50.1.0 10.10.1.1 command to add a route.
Run the netstat -r command to query the information about the current routing
table.
– In the Windows OS, do as follows:
Run the route add 10.50.1.0 mask 255.255.255.0 10.10.1.1 command to add a
route.
Run the route print command to query the information about the current routing
table.
NOTE
If the IP address of the outband network management port and the IP address of the U2000 are
in the same network segment, you need not configure the routing information.
2. Log in to the U2000.
3. Set the SNMP parameters. A default SNMP profile exists in the system. Use the default
profile in this service. If a new profile is required, do as follows:
a. Choose Administration > NE Communicate Parameter > Default Access
Protocol Parameters from the main menu.
b. – When the SNMP V1 is used, choose SNMP v1 Parameter on the Default
Access Protocol Parameters tab page. Then click Add and set the SNMP
parameters, as shown in the following figure (the other parameters except
Profile name use the default settings).
Figure 1-62 Set the SNMP parameters
– When the SNMP V2 is used, choose SNMP v2 Parameter on the Default
Access Protocol Parameters tab page. Then click Add and set the SNMP
parameters, as shown in the following figure (the other parameters except
Profile name use the default settings).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Commissioning
152