Configuring The Ftp Transfer Mode - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

1.6.2.1 Configuring the FTP Transfer Mode

This topic describes how to configure the FTP transfer mode for transferring (uploading or
downloading) files through the inband or outband Ethernet port of the MA5600T/MA5603T/
MA5608T. After the configuration, the FTP server and the MA5600T/MA5603T/MA5608T can
communicate to transfer files in the FTP mode.
Prerequisites
l
l
Tools, Meters, and Materials
l
l
Impact on System
None
Precautions
Make sure that the crossover cable is used to directly connect the FTP server to the MA5600T/
MA5603T/MA5608T. In other cases, a straight-through cable is used.
Procedure
Step 1 On the FTP server, configure the IP address of its Ethernet port.
Configure the Ethernet port IP address of the FTP server according to the IP address planning
in the specific networking, and ensure that the Ethernet port of the FTP server and the inband
or outband Ethernet port of the MA5600T/MA5603T/MA5608T can ping each other.
For example, if the Ethernet port of the FTP server is directly connected to the MA5600T/
MA5603T/MA5608T, the IP address of this Ethernet port and the IP address of the inband or
outband Ethernet port of the MA5600T/MA5603T/MA5608T must be in the same subnet.
Step 2 On the FTP server, run the FTP application and set related parameters.
After running the FTP application, set the path for saving the file, FTP user name, and password.
Step 3 (This is step is used for setting the FTP user attributes for the manual file transfer.) On the
MA5600T/MA5603T/MA5608T, run the ftp set command to set the FTP user name and
password.
huawei(config)#ftp set
User Name(<=40 chars):huawei
User Password(<=40 chars):huawei//The input is not displayed on the CLI.
Issue 01 (2014-04-30)
The Ethernet port of the FTP server is directly connected to the inband or outband Ethernet
port of the MA5600T/MA5603T/MA5608T.
– Connect to the inband Ethernet port (Upstream port) through the crossover cable.
– Connect to the outband Ethernet port (Maintenance port) through the direct cable.
You have logged in to the MA5600T/MA5603T/MA5608T remotely from the console
(maintenance terminal), and have entered the global config mode.
Crossover cable
Direct cable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Commissioning
195