Huawei SmartAX MA5603T Configuration Manual page 453

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 3 Configure a VLAN and enable MPLS for the VLAN and the VLAN interface.
Add VLAN 4001 for forwarding MPLS packets and add an upstream port to it.
huawei(config)#vlan 4001 smart
huawei(config)#port vlan 4001 0/19/0
Enable MPLS for VLAN 4001.
huawei(config)#mpls vlan 4001
Set the IP address of VLAN interface 4001 to 10.50.50.50/24 and enable MPLS LDP for the
VLAN interface.
huawei(config)#interface vlanif 4001
huawei(config-if-vlanif4001)#ip address 10.50.50.50 24
huawei(config-if-vlanif4001)#mpls
huawei(config-if-vlanif4001)#mpls ldp
huawei(config-if-vlanif4001)#quit
Step 4 Configure a route.
PWE3 has no special requirements for the routing policy. A static route, or dynamic RIP, or
OSPF route can be configured. An OSPF dynamic route is recommended because OSPF supports
MPLS RSVP-TE extension.
Set the OSPF process ID to 100 and OSPF area ID to 1. In addition, configure the interfaces
(VLAN interface and loopback interface) that run OSPF and configure the areas of the interfaces.
huawei(config)#ospf 1
huawei(config-ospf-1)#area 100
huawei(config-ospf-1-area-0.0.0.100)#network 10.50.50.0 0.0.0.255
huawei(config-ospf-1-area-0.0.0.100)#network 3.3.3.3 0.0.0.0
huawei(config-ospf-1-area-0.0.0.100)#return
Step 5 Configure PW parameters.
1.
2.
3.
4.
5.
6.
Issue 01 (2014-04-30)
Create PW 3 and enter the PW parameter mode.
huawei(config)#pw-para 3
Configure the loopback interface IP address of the remote PTN device in the PW.
Set the loopback interface IP address to 10.10.10.10.
huawei(config-pw-para-3)#peer-address 10.10.10.10
Set the PW type to TDM SAToP E1.
huawei(config-pw-para-3)#pw-type tdm satop e1
Configure the PW load time.
Set the load time to 125 μs.
huawei(config-pw-para-3)#tdm-load-time satop e1 loadtime 125
(Optional) Enable RTP. After RTP is enabled, PW packets of the TDM type contain the
RTP control header. By default, RTP is disabled.
NOTE
The RTP configuration must be the same as that on the PTN.
huawei(config-pw-para-3)#rtp-header
(Optional) Configure the jitter buffer size. The jitter buffer can effectively prevent jitter
and delay. Only PW parameters of the TDM type support the jitter buffer configuration.
By default, the jitter buffer size is 2000 μs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
428