Huawei SmartAX MA5603T Configuration Manual page 351

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
The data plan of the PSTN service based SIP protocol
SIP interface ID
PSTN port
(The data
configuration
must be the same
as the data
configuration on
the IMS.)
Procedure
l
Issue 01 (2014-04-30)
TID
Phone number
Automatic
deactivation
Activation
mode
Frame/slot/port
Numbers of
Phone
User priority
User type
PSTN port
attributes
Configure the H.248-based ISDN service
1. Configure the working mode of the ISDN BRA port.
In the BRA port mode, configure the working mode of the ISDN BRA port to P2P,
configure the activation mode to stable activation, and disable automatic activation.
huawei(config)#braport
huawei(config-braport)#braport attribute set 0/2/0 workmode p2p
activemode stable-active autodeactive disable
huawei(config-braport)#quit
2. Add an IUA link set and IUA links.
In the SIGTRAN mode, configure the SIGTRAN protocol stack. Add an IUA link set,
and then add IUA links.
huawei(config)#sigtran
huawei(config-sigtran)#iua-linkset add 1 mgid 0 jointly-work enable
trafficmode override
iid-map 2 pendingtime 1 cs-mode client
huawei(config-sigtran)#iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
huawei(config-sigtran)#quit
NOTE
All the ISDN call control messages are sent from the IUA link to the softswitch, whereas the
system uses the bearer control messages to communicate with the softswitch through H.248.
3. Configure the ISDN BRA user data.
huawei(config)#esl user
huawei(config-esl-user)#mgbrauser add 0/2/0 0 1 interfaceid 8 terminalid
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Data
100, 110
12345601, 12345602
Disabled
Stable activation
0
0/3/0, 0/3/1.
83110000, 83110001
Cat2
Payphone
Polarity reversal pulse supported
326