Configuring Sip Voice Service (On The Onu) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#quit
NOTE
l You must cold reset the MG interface after configuring. Otherwise, the MG interface does not take effect.
l The MG interface can be cold reset only after parameters mgip, mgport, primary-mgc-ip1 (or mgc-domain-
name1), mgcport_1, code, transfer, and mg-media-ip are correctly configured.
Step 8 Configure the PSTN user data.
Configure phone numbers of users 0/3/0-0/3/23 to 83110001-83110024 in batches and terminal
identification to 0.
l Phone numbers are used for only internal emergency standalone, that is, internal extensions
call each other. Actual phone numbers are assigned by the MGC.
l If the user of the MG interface is configured to support terminal layering, you need not
configure the terminal identification because the system automatically allocates it. If the user
of the MG interface does not support terminal layering, the terminal identification is
mandatory. The terminal identification must be unique on one MG interface.
huawei(config)#esl user
huawei(config-esl-user)#mgpstnuser batadd 0/3/0 0/3/23 0 terminalid 0 telno
83110001
Step 9 Configure the call priority of a PSTN user.
huawei(config-esl-user)#mgpstnuser modify 0/3/0 priority cat2
huawei(config-esl-user)#quit
Step 10 Configure all the PSTN ports to support polarity reversal.
Configure the physical attributes of the PSTN port to which the users belong to support polarity
reversal so that the user supports polarity reversal accounting.
huawei(config)#pstnport
huawei(config-pstnport)#pstnport attribute batset 0/3/0 0/3/23 reverse-pole-pulse
enable
huawei(config-pstnport)#quit
Step 11 Save the data.
huawei(config)#save
----End

11.3.1.8 Configuring SIP Voice Service (on the ONU)

This topic describes how to configure voice services based on the Session Initiation Protocol
(SIP) on an optical network unit (ONU). The voice over IP (VoIP) services have high quality,
but require low cost.
Prerequisites
l
l
Issue 01 (2014-04-30)
The IP Multimedia Subsystem (IMS) interface data and public switched telephone network
(PSTN) user data corresponding to the SIP interface is configured on the IMS.
Status of the voice board on the ONU is normal. (To verify board status, run the display
board 0 command.)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
872