Huawei SmartAX MA5603T Configuration Manual page 249

Access module

Hide thumbs Also See for SmartAX MA5603T:

Table of Contents

SmartAX MA5600T/MA5603T/MA5608T Multi-service

Access Module

Commissioning and Configuration Guide

Issue 01 (2014-04-30)

Configure the physical attributes of an Ethernet port.

(Optional) Set the auto-negotiation mode of the Ethernet port.

Run the auto-neg command to set the auto-negotiation mode of the Ethernet port. You

can enable or disable the auto-negotiation mode:

– After the auto-negotiation mode is enabled, the port automatically negotiates with

the peer port for the rate and working mode of the Ethernet port.

– After the auto-negotiation mode is disabled, the rate and working mode of the port

are in the forced mode (adopt default values or are set through command lines).

The mode (auto-negotiation mode or forced mode) of the OLT port must be consistent

with that of the interworking port. Otherwise, the communication fails.

(Optional) Set the rate of the Ethernet port.

Run the speed command to set the rate of the Ethernet port. After the port rate is set

successfully, the port works at the set rate. Pay attention to the following points:

– Make sure that the rate of the Ethernet port is the same as that of the interconnected

port on the peer device. This prevents communication failure.

– The auto-negotiation mode should be disabled.

(Optional) Set the duplex mode of the Ethernet port.

Run the duplex command to set the duplex mode of the Ethernet port. The duplex

mode of an Ethernet port can be full-duplex, half-duplex, or auto negotiation. Pay

attention to the following points:

– Make sure that the ports of two interconnected devices work in the same duplex

modes. This prevents communication failure.

Huawei Proprietary and Confidential

disabled, you

configure the

2 Basic Configurations

Show Quick Links

Table of Contents

Smartax ma5600t Smartax ma5608t