Huawei SmartAX MA5603T Configuration Manual page 895

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Item
NOTE
The data
configurati
on must be
the same as
the data
configurati
on on the
MGC.
Voice user
configuratio
n data
Common
parameter
Procedure
Step 1 Log in to and configure the ONU.
You can remote log in to the ONU from the OLT to perform the configuration. The user name
is root and the password is mduadmin.
Step 2 Configure the upstream VLAN interface.
Specify the upstream VLAN interface for the media stream and the signaling flows and configure
the IP addresses of the Layer 3 interface. These IP addresses are the sources of the IP address
pools for the media stream and the signaling flows.
Issue 01 (2014-04-30)
paramet Media IP address and
ers signaling IP address
Default gateway IP address 10.10.10.1/24
MG interface ID
Signaling port ID
IP address of the primary MGC
Port ID of the primary MGC
Coding
Transmission mode
H248 version that MG starts to
negotiate
Phone number
Terminal identification
User priority
User type
System parameter
Overseas parameter
PSTN port attribute
Ringing current attribute
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
Data
10.10.10.10/24
0
2944
200.200.200.200/24
2944
Text
UDP
1 (the negotiation starts from V1)
83110001-83110024
Terminal layering is not supported
and the terminal identification
ranges from 0 to 23.
Cat2 for phone 1
Cat3 for phone 2 to phone 24
(default)
Common user (DEL user by default)
Default value
Default value
Polarity-reversal
Default value
870