Huawei SmartAX MA5603T Configuration Manual page 115

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Monitoring Parameter Displayed on the
Host
Digital 5
Digital 6
NOTE
Configuration Process
The monitoring parameters can be reported to the control system only when the data for the
EPS30-4815AF is configured correctly in the system.
Table 1-26
Table 1-26 Commands for configuring the EPS30-4815AF
To...
Add an EMU
Query the configuration
parameters of the power system
Query the power environment
parameters
Query the alarm information of
the power supply
Configure the battery charging
parameters
Configure the battery
management parameters
Configure the upper/lower
temperature alarm limits or the
upper/lower temperature test
limits
Configure the battery set power-
off parameters
Configure the power distribution
parameters
Configure the battery
discharging test parameters
Issue 01 (2014-04-30)
Before adding a user-defined analog or monitoring digital parameter, make sure that the port corresponding
to this parameter is properly connected to an environment monitoring cable.
lists the commands used during the configuration.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Device Port
JTD6
JTD7
Run the Command...
emu add
display power system parameter
display power environment parameter
display power alarm
power charge
power battery parameter
power battery temperature
power off
power supply-parameter
power battery-test
1 Commissioning
90