Configuring The Internet Access Service - Huawei SmartAX MA5603T Configuration Manual

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
F/S/P
ONT-ID
Control flag
activated.
Run state
successfully.
Config state
ONT is normal.
Match state
the ONT is consistent with the actual capability of the ONT.
...//The rest of the response information is omitted.
When Config state is failed, Run state is offline, or Match state is mismatch:
l If Control flag is deactive, run the ont active command in GPON mode to activate the ONU.
l If Run state is offline, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
l If Config state is failed, the configured ONU capability exceeds the actual ONU capability.
In this case, run the display ont failed-configuration command in the diagnose mode to
check the failed configuration item and the failure cause. Then, rectify the fault accordingly.
l If the ONU does not match, that is, Match state is mismatch, the port types and number of
ports undermatch the actual port types and number of ports supported by the ONU. In this
case, run the display ont capability command to query the actual capability of the ONU,
and then select one of the following modes to modify the ONU configuration:
– Create a proper ONU profile according to the actual capability of the ONU, and then run
– Modify the ONU profile according to the actual capability of the ONU and save the
----End

9.7.2.4 Configuring the Internet Access Service

The OLT is connected to the remote ONT through a GPON port to provide users with high-
speed Internet access services.
Prerequisites
l
l
l
l
l
l
Issue 01 (2014-04-30)
: 0/1/0
: 1
: active
: online
: normal
: match
the ont modify command to modify the configuration data of the ONU.
modification. Then, the ONU automatically recovers the configuration successfully.
The OLT is connected to the BRAS.
Related configurations are performed on the BRAS according to the authentication and
accounting requirements for dialup users. For details about the configuration, see the
configuration guide.
The ONT has been added to the OLT. For details, see
OLT.
The VLAN of the LAN switch port connected to the OLT is consistent with the upstream
VLAN of the OLT.
Residential users generally access the Internet in Point-to-Point Protocol over Ethernet
(PPPoE) dial-up mode. PPPoE dial-up can be performed on personal computers (PCs) or
HGWs.
The configuration processes on HGWs of different models or in different appearances are
similar. This topic describes how to configure the Internet access service on an HG239 that
is connected to an ONT upstream through a LAN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
//Indicates that the ONT is
//Indicates that the ONT goes online
//Indicates that the configuration state of the
//Indicates that the capability profile bound to
9.7.1.3 Adding an ONT to an
9 FTTH Configuration
635

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents