Huawei SmartAX MA5603T Configuration Manual page 387

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
Issue 01 (2014-04-30)
huawei(config-if-sip-0)#reset
Are you sure to reset SIP interface?(y/n)[n]:y
6. Confirm the service board.
Confirm the ASPB service board that carries services so that the board can work in
the normal state.
huawei(config)#board confirm 0/2
7. Configure the PSTN user data.
Add POTS users (phones 0-31) to VAG1 so that the users can go online.
huawei(config)#esl user
huawei(config-esl-user)#sippstnuser batadd 0/2/0 0/2/31 0 telno 80000000
huawei(config-esl-user)#quit
8. Save the data.
huawei(config)#save
Configure VAG2.
1. Add the upstream VLAN interface.
According to the data plan, configure the IP address of the Layer 3 interface to
10.20.10.11, which facilitates the configuration of the media and signaling IP address
pools.
When you need to connect the VLAN interface to multiple subnets and configure the
secondary IP address, use sub parameter. The secondary IP address is the same as the
primary IP address in function. They are used for Layer 3 forwarding.
In step Step 1, the VLAN is added and the IP address of the VLAN Layer 3 interface
is configured. In this step, use the sub parameter to configure the secondary IP address
of the VLAN. The secondary IP address is the same as the primary IP address in
function. They are used for Layer 3 forwarding.
huawei(config)#interface vlanif 30
huawei(config-if-vlanif30)#ip address 10.20.10.11 24 sub
huawei(config-if-vlanif30)#quit
2. Configure the media and signaling IP address pools.
Add the IP address of the VLAN Layer 3 interface configured in the previous step to
the media and signaling IP address pools respectively. Therefore, the media and
signaling IP addresses used for the services can be selected from the IP address pools.
According to the data plan, IP address 10.20.10.11 is added to the media and signaling
IP address pools, and the gateway IP address corresponding to the media IP address
is 10.20.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 10.20.10.11 10.20.10.1
huawei(config-voip)#ip address signaling 10.20.10.11
huawei(config-voip)#quit
3. Configure a static route to the IMS.
Make sure that the route between the local device and the IMS is reachable. The static
route is used as an example. If the static route has been configured, skip this step.
huawei(config)#ip route-static 10.20.0.0 255.255.0.0 10.20.10.1
4. Add a SIP interface.
According to the data plan, add SIP interface 1, and configure the interface attributes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
362