Huawei SmartAX MA5603T Configuration Manual page 482

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
7.
Step 3 Configure the time server.
huawei(config)#ntp-service unicast-server 4.4.4.4 source-interface vlanif 10
huawei(config)#ntp-service unicast-server 4.4.4.5 source-interface vlanif 10
Step 4 Configure the log host.
huawei(config)#loghost add 3.3.3.3 syslog-1
huawei(config)#loghost activate ip 3.3.3.3
huawei(config)#loghost add 3.3.4.3 syslog-2
huawei(config)#loghost activate ip 3.3.4.3
Step 5 Configure the EMU.
This topic uses the fan and the PS4875L power supply as an example to describe how to configure
the EMU.
By default, the default slave node number of the fan EMU is 0. In this example, assume that the
slave node number is 1. In this case, you need to set the DIP switch of the node address on the
fan monitoring unit to 1.
huawei(config)#emu add 0 power4875l 0 0
huawei(config)#emu add 1 fan 0 1
huawei(config)#interface emu 0
huawei(config-if-power4875l-0)#power module-num 2 1 2
huawei(config-if-power4875l-0)#quit
Step 6 Configure GIU subtending.
MA5600T/MA5603T/MA5608T-1 is subtended with MA5600T/MA5603T/MA5608T-2,
MA5600T/MA5603T/MA5608T-3 and MA5600T/MA5603T/MA5608T-4. Therefore, the
subtending should be configured.
Step 7 Configure MSTP.
1.
2.
3.
4.
Step 8 Enable PITP.
huawei(config)#pitp enable pmode
Step 9 Configure ADSL2+ service.
The MA5600T/MA5603T/MA5608T supports the ADSL2+ service of multiple encapsulation
modes, such as IPoA, PPPoA, IPoE, and PPPoE. This topic uses the PPPoE mode as an example
Issue 01 (2014-04-30)
huawei(config)#snmp-agent target-host trap-hostname huawei123 address 2.2.2.3
trap-paramsname 123
Set the trap source address.
huawei(config)#snmp-agent trap source vlanif 10
Enable the MSTP function.
huawei(config)#stp enable
Change global stp state may active region configuration,it may take
several
minutes,are you sure to change global stp state? [Y/N][N]
Y
Set the MST region name.
huawei(config)#stp region-configuration
huawei(stp-region-configuration)#region-name hwrg
Configure MSTP instance 1.
huawei(stp-region-configuration)#instance 1 vlan 1 to 4094
Activate the configuration of the MST region.
huawei(stp-region-configuration)#active region-configuration
STP actives region configuration, it may take several minutes,are you sure
to
active region configuration? [Y/N][N]y
huawei(stp-region-configuration)#quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Example of MSTP Subtending Network
457