Huawei SmartAX MA5603T Configuration Manual page 191

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Figure 1-74
(H.248).
Figure 1-74 Flowchart for commissioning the interconnection with the MG interface(H.248)
Prerequisites
l
l
Procedure
Step 1 Configure the upstream VLAN interface for the media stream and the signaling stream.
The VLAN ID is 50, the VLAN type is smart VLAN, the upstream port is 0/19/0, and the IP
address of the VLAN interface is 10.50.1.10/24.
huawei(config)#vlan 50 smart
huawei(config)#port vlan 50 0/19 0
huawei(config)#interface vlanif 50
huawei(config-if-vlanif50)#ip address 10.50.1.10 24
huawei(config-if-vlanif50)#quit
Issue 01 (2014-04-30)
shows the flowchart for commissioning the interconnection with the MG interface
The data configuration on the MGC side (corresponding to the data configuration on the
MG side) must be correct.
The current system must use the H.248 protocol.
NOTE
Run the display protocol support command to query the current voice protocol. If the voice protocol
is not H.248, run the protocol support h248 command to change it to H.248.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Commissioning
166