Huawei SmartAX MA5603T Configuration Manual page 731

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Remote
Service
Verificati
on
Method
Call
Emulation
Multicast
emulation
Data plan
Item
PPPoE
dialup
emulation
parameters
Call
emulation
parameters
Multicast
emulation
parameters
Procedure
l
Issue 01 (2014-04-30)
Function
An ONT simulates a voice user to
make a call to check whether the
voice service data is correctly
configured. You can also use the
call emulation function to locate a
fault when the voice service is
faulty.
This function enables you to
simulate a multicast user going
online and lead the program
stream to an ONT. You can check
whether the multicast service is
normal by checking the real-time
traffic of the multicast program.
Data
PPPoE user name: test@huawei
Password: test
ONT POTS ID: 1
Multicast service flow ID: 1
MVLAN: 1000
IP address of the multicast
program: 224.1.1.10
Verify the Internet access service using PPPoE dialup emulation.
1. In the xPON board mode, run the pppoe simulate start command to start a PPPoE
dialup emulation test. The following test uses GPON as an example:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
Description
l An ONT can simulate a caller or callee
to communicate with a phone in a call.
In this case, only a functional phone is
required in the central office where the
acceptance personnel is.
l An ONT supports a maximum of a call
emulation.
Multicast services configured in the
dynamic controllable multicast mode do
not support this function.
Remarks
The user name, password, and
authentication mode for the emulation test
must be configured on the BRAS. The
entered user name, password, and
authentication mode must be consistent
with those configured on the BRAS.
The default values are used. You can run
the display pots emulational
configuration command to check the
parameter values.
-
706