Huawei SmartAX MA5603T Configuration Manual page 721

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Step 9 Apply and bind an ONT voice service profile to an SIP interface
Currently, the interface common profile, SIP agent profile, SIP service data profile, and POTS
port profile can be applied to an SIP interface, and the digitmap profile can be bound to an SIP
interface.
For profiles that can be applied to an SIP interface, if parameters in those profiles are changed,
those profiles must be reapplied to the SIP interface so that the changed parameters can take
effect. For profiles that can be bound to an SIP interface, if parameters in those profiles are
changed, those profiles do not need to be rebound to the SIP interface and the changed parameters
can take effect.
The method for applying an SIP agent profile is introduced in
introduce the methods for applying an interface common profile, an SIP service data profile,
and a POTS port profile, and the method for binding a digitmap to an SIP interface.
1.
2.
Issue 01 (2014-04-30)
Run the display sippstnuser attribute command to check whether the configuration of
the POTS user is properly set.
huawei(config-if-gpon-0/1)#display sippstnuser attribute 0 1 1
------------------------------------------------------------------------------
F/S/P
ONT ID
Port ID
MG ID
Telephone NO.
User name
Password
...//The rest of the response information is omitted.
huawei(config-if-gpon-0/1)#display sippstnuser attribute 0 2 1
------------------------------------------------------------------------------
F/S/P
ONT ID
Port ID
MG ID
Telephone NO.
User name
Password
...//The rest of the response information is omitted.
Apply an interface common profile.
Run the if-sip attribute command to apply an interface common profile to an SIP interface
or configure the interface customized parameters, or run the ont-if-sip bat-apply from
command to bulk apply the interface common profiles to SIP interfaces. If you use these
two commands to apply the interface common profiles or configure the interface
customized parameters repeatedly, the last configurations take effect.
In this example, the default interface common profile, namely interface common profile 1
is used.
Apply an SIP service data profile.
Run the sippstnuser rightflag command to apply an SIP service data profile to an SIP
interface or configure the interface customized parameters, or run the ont-sippstnuser bat-
apply from command to bulk apply the SIP service data profiles to SIP interfaces. If you
use these two commands to apply the SIP service data profiles or configure the interface
customized parameters repeatedly, the last configurations take effect.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: 0/1/0
: 1
: 1
: 1
: 77730010
: huawei1
: user1
: 0/1/0
: 2
: 1
: 1
: 77730020
: huawei2
: user2
Step
9 FTTH Configuration
8.1. The following will
696