Huawei SmartAX MA5603T Configuration Manual page 615

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Issue 01 (2014-04-30)
(default telecomadmin) and password (default admintelecom) of the administrator.
After the password is authenticated, the web configuration window is displayed.
NOTE
l The following configuration procedure is for scenarios with the bridging ONT. For scenarios with the
bridging ONT+HGW, configure the voice service on the HGW but not on the ONT. For detailed
configurations, see the HGW Configuration Guide.
l The Web page for configuring ONT varies with ONT versions, but the parameter configuration is the
same. For details, see relevant ONT manuals.
1. Configure the voice protocol.
NOTE
The default voice protocol is SIP. Therefore, change the voice protocol first.
a. Choose Voice > SIP/H.248 Protocol Conversion.
b. In the pane on the right, set Voice to H.248.
c. Click Apply.
2. Configure parameters for the voice WAN interface.
a. Choose WAN > WAN Configuration.
b. In the right pane, click New. In the dialog box that is displayed, set the parameters
as follows:
– Select Enable WAN Connection to enable the new WAN connection.
– Set Encapsulation mode to IPoE.
– Set Service Type to VOIP. (For configuring the VoIP service, VoIP or a
combination containing VoIP needs to be selected.)
– Set WAN mode to Route WAN.
– Select Enable VLAN.
– Set VLAN ID to 300. (The VLAN ID of the ONT must be the same as the
user-side VLAN ID configured on the OLT.)
– Set 802.1p to 5.
– Set IP Acquisition Mode to DHCP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
590