Example: Configuring The Voip Service (Mgcp-Based) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
pstnport
pstnport attribute batset 0/3/0 0/3/31 reverse-pole-pulse enable
quit
Save the data.
save

3.3.2 Example: Configuring the VoIP Service (MGCP-based)

This topic describes how to configure the MGCP-based VoIP service.
Service Requirements
In an office located in China, the MA5600T/MA5603T/MA5608T that adopts the MGCP
protocol is newly deployed. Data plan and configuration, however, are not performed on the
MGC (softswitch) connected to the MA5600T/MA5603T/MA5608T. The MA5600T/
MA5603T/MA5608T is required to provide the following VoIP services:
l
l
After the service requirements are further confirmed and analyzed with the service provider, the
data plan is made by considering the interconnection with the MGC and according to the data
plan described in Configuring the VoIP Service (H.248-based or MGCP-based).
provides the data plan for configuring the MGCP-based VoIP service.
Table 3-4 Data plan for configuring the MGCP-based VoIP service
Item
MG interface
data
(The data
configuration
must be the
same as the data
configuration
on the MGC.)
Issue 01 (2014-04-30)
The common phone services are provisioned to 32 users (phones 0-31).
The polarity-reversal accounting is adopted.
Media and
signaling
parameter
s
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
Media and Standard VLAN is recommended as
signaling the upstream VLAN of the VoIP
upstream VLAN service. Standard VLAN 20 is adopted.
Media and In this office, all the services are
signaling transmitted upstream through the
upstream port upstream interface board. Therefore,
port 0/19/0 is used as the upstream port
of the VoIP service.
Media and These two IP addresses are both
signaling IP 10.10.10.10/24.
address
NOTICE
The MGCP interface on the MA5600T/
MA5603T/MA5608T does not support the
isolation of media streams and signaling
flows. Therefore, when the MGCP protocol
is used, the media IP address pool and the
signaling IP address pool must be the same.
When the H.248 or SIP protocol is used, the
media IP address pool and the signaling IP
address pool can be the same or different.
3 Configuring the DSLAM Services
Table 3-4
309