Huawei SmartAX MA5603T Configuration Manual page 449

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config)#display pw-ac-binding tdm 1
Total : 1
----------------------------------------------------------------------------
TDM
ID
----------------------------------------------------------------------------
1
----------------------------------------------------------------------------
Note
Step 11 Configure clock synchronization on the E1 port.
Configure the recovery clock source of the H802EDTB board. In the recovery clock mode, the
receive end recovers the clock of the transmit end according to the average arrival rate of the
received SAToP packets. In this example, clock signals are extracted from PW2 to serve as the
recovery clock of a board.
huawei(config)#interface edt 0/3
huawei(config-edt-0/3)#adapt-clock-source clock-source 0 2
Configure the Tx clock of E1 port 0/3/1 on the H802EDTB board as the network-side clock.
That is, configure the clock recovered from a TDM PW as the Tx clock of a port, implementing
voice service synchronization.
huawei(config-edt-0/3)#clock-work 1 net
----End
Result
After a network is restructured, the long-term bit error ratio and latency meet the requirements
for actual applications, the Nx64k private line service or ISDN PRI PBX service runs normally,
and the operation method for end users is not changed.
Configuration File
interface loopback 0
ip address 3.3.3.3 32
quit
mpls lsr-id 3.3.3.3
mpls
lsp-trigger host
quit
mpls l2vpn
mpls ldp
quit
vlan 4001 smart
port vlan 4001 0/19/0
mpls vlan 4001
interface vlanif 4001
ip address 10.50.50.50 24
mpls
mpls ldp
quit
ospf 1
area 100
network 10.50.50.0 0.0.0.255
network 3.3.3.3 0.0.0.0
return
interface tunnel 10
tunnel-protocol mpls ip
destination 9.9.9.9
quit
Issue 01 (2014-04-30)
(Up/Down :
1/0
PW
ID
2
: F--Frame, S--Slot, P--Port
*: Secondary
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
Static/LDP :
PW
PROTO
RECEIVE TRNS
STATE TYPE
LABEL
LABEL
up
LDP
---
---
0/1)
PW
INDEX
2
424

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents