Huawei SmartAX MA5603T Configuration Manual page 785

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
Issue 01 (2014-04-30)
Run the display traffic table ip command to query the existing traffic profiles in the
system. If the existing traffic profiles in the system do not meet the requirements, run
the traffic table ip command to add a traffic profile.
Set the profile name to fttd_voip and do not limit the upstream and downstream rates.
Set the priority to 5 and packets are scheduled according to the priority carried.
huawei(config)#traffic table ip name fttd_voip cir off priority 5 priority-
policy
local-setting
2. Configure the mapping between a GEM port and a VLAN.
The service flow of user VLAN 300 is mapped to GEM port 12 in the ONU line profile.
huawei(config)#ont-lineprofile gpon profile-name fttd
huawei(config-gpon-lineprofile-1)#gem mapping 12 2 vlan 300
huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
3. Create a service VLAN and add an uplink port to it.
Add uplink port 0/19/0 to VLAN 300.
huawei(config)#vlan 300 smart
huawei(config)#port vlan 300 0/19 0
4. Create service flows.
Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 300, and use
traffic profile fttd_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-
service
user-vlan 300 inbound traffic-table name fttd_voip outbound traffic-table
name
fttd_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-
service
user-vlan 300 inbound traffic-table name fttd_voip outbound traffic-table
name
fttd_voip
5. Enable the ARP proxy function.
Voice media streams for different users of the same SVLAN fail to interchange
because the service ports of the smart VLAN are isolated from each other. Therefore,
the ARP proxy function needs to be enabled on the OLT.
huawei(config)#arp proxy enable
huawei(config)#interface vlanif 300
huawei(config-if-vlanif300)#arp proxy enable
huawei(config-if-vlanif300)#quit
6. Save the data.
huawei(config)#save
Configure the ONU on the Web page.
Log in to the web configuration window.
1. Configure the IP address of the PC network adapter to be in the same network segment
with the IP address of the local maintenance Ethernet port on the ONU (default:
192.168.100.1).
2. Open the Web browser, and enter the IP address of the local maintenance Ethernet
port on the ONU. In the login window, enter the user name (default: telecomadmin)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 FTTD Configuration
760