Huawei SmartAX MA5603T Configuration Manual page 368

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
huawei(config)#board add 0/2 h802EDTB
Step 2 Add an IUA link set and IUA links.
In the SIGTRAN mode, configure the SIGTRAN protocol stack. Add an IUA link set, and then
add IUA links.
huawei(config)#sigtran
huawei(config-sigtran)#iua-linkset add 1 mgid 0 jointly-work enable trafficmode
override
iid-map 2 pendingtime cs-mode client
huawei(config-sigtran)#iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
NOTE
Step 3 Configure the ISDN PRA user data.
huawei(config-sigtran)#quit
huawei(config)#esl user
huawei(config-esl-user)#mgprauser add 0/2/0 0 1 interfaceid 1 terminalid 512
Each ISDN PRA user occupies 32 TIDs. You need to input only the first TID when adding an
ISDN PRA user.
l When the TID profile to which the ISDN PRA user of the MG interface is bound is not a
layering profile, the TID must be configured and cannot be within the configured TID range.
l When the TID profile to which the ISDN PRA user of the MG interface is bound is a layering
profile, the configuration of the TID parameter is not available because the system
automatically allocates the TID.
Step 4 Save the data.
huawei(config-esl-user)#quit
huawei(config)#save
----End
Result
After the configuration is completed, all the users of the PBX can communicate with Phone B
in the normal state.
Configuration File
board add 0/2 h802EDTB
sigtran
iua-linkset add 1 mgid 0 jointly-work enable trafficmode override
iid-map 2 pendingtime cs-mode client
iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
quit
esl user
mgprauser add 0/2/0 0 1 interfaceid 1 terminalid 512
quit
save
Issue 01 (2014-04-30)
All the ISDN call control messages are sent from the IUA link to the softswitch, whereas the system uses
the bearer control messages to communicate with the softswitch through H.248.
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
343

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents