Example: Configuring The P2Mp Isdn Bra Service - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
disable
braport attribute set 0/3/0 workmode p2p activemode stable-active autodeactive
disable
quit
esl user
sipbrauser add 0/2/0 0 telno 12345601
sipbrauser add 0/3/0 0 telno 12345602
quit
save

3.3.7 Example: Configuring the P2MP ISDN BRA Service

This topic describes how to configure the P2MP ISDN BRA service on the MA5600T/
MA5603T/MA5608T, which is applicable to the scenario where one NT1 is connected to
multiple terminals.
Service Requirements
l
l
Prerequisite
l
Networking
Figure 3-15
Issue 01 (2014-04-30)
Two ISDN digital phones are connected to the MA5600T/MA5603T/MA5608T through
the same NT1.
Basic rate interface (BRI) is adopted between the NT1 and the MA5600T/MA5603T/
MA5608T to provide a rate of 144 kbit/s, including two B channels and one D channel.
The MG interface and the system parameters must be configured. For the related operations,
see Configuring an MG Interface and (Optional) Configuring the System Parameters. The
MG interface must be in the normal state.
shows an example network of the P2MP ISDN BRA service.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
335