Configuring H.248 Voice Service (On The Onu) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
----End

11.3.3.10 Configuring H.248 Voice Service (on the ONU)

This topic describes how to configure the voice service on the ONU based on the H.248 protocol
to provide the high quality and low cost VoIP service for users.
Prerequisites
l
l
Precautions
1.
2.
Issue 01 (2014-04-30)
huawei(config)#xdsl vectoring enable
6. Save the data.
huawei(config)#save
Configuration procedure for the MA5603T:
1. Log in to the ONU remotely and start the configuration.
By default, the user name is root and the password is admin.
2. Globally configure the band plan type.
huawei(config)#xdsl vectoring bandplan-type 998ade us0-type type-a
3. Configure the vectoring profile as huawei and bind it to the VDSL2 port in the
vectoring group.
huawei(config)#xdsl vectoring-profile add control enable enable name
huawei
huawei(config)#interface vdsl 0/1
huawei(config-if-vdsl-0/1)#vectoring-config all profile-name huawei
huawei(config-if-vdsl-0/1)#quit
4. Configure the policy for activating a vectoring legacy CPE.
huawei(config)#xdsl vectoring legacy-cpe activate-policy no-limit
5. Configure the policy for controlling frequent online and offline on ports.
huawei(config)#xdsl frequent-retrain-control 0/1/0 control-policy no-limit
6. Enable the global vectoring.
huawei(config)#xdsl vectoring enable
7. Save the data.
huawei(config)#save
The media gateway controller (MGC) interface data and the PSTN user data corresponding
to the media gateway (MG) interface is configured on the MGC.
Ensure that the Status of the voice board on the ONU is Normal by running the display
board 0 command.
An ONU supports both the H.248 and SIP protocols; however, these two protocols are
mutually exclusive. You can run the display protocol support command to query the
currently supported voice protocol.
If the voice protocol needs to be switched, you need to delete the MG interface first and
run the protocol support command to switch the protocol. After the configuration is
complete, save the configuration and restart the system to make the configured protocol
take effect.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
952