Configuring The Service Channel Between The Olt And The Onu - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Procedure
Step 1 Configure the inband management VLAN and IP address of the OLT.
Configure the inband management VLAN to 8, VLAN priority to 6, and the IP address to
192.168.50.1/24.
huawei(config)#vlan 8 smart
huawei(config)#port vlan 8 0/19 0
huawei(config)#vlan priority 8 6
huawei(config)#interface vlanif 8
huawei(config-if-vlanif8)#ip address 192.168.50.1 24
huawei(config-if-vlanif8)#quit
Step 2 Configure the inband management VLAN and IP address of the ONU.
Configure the static IP address of the ONU to 192.168.50.2/24, gateway to 192.168.50.254, and
the management VLAN ID to 8 (the same as the management VLAN of the OLT).
huawei(config)#interface gpon 0/2
huawei(config-if-gpon-0/2)#ont ipconfig 1 1 static ip-address 192.168.50.2 mask
255.255.255.0 gateway
192.168.50.254 vlan 8
huawei(config-if-gpon-0/2)#quit
Step 3 Configure an inband management service port.
Configure the management service port ID to 1, management VLAN ID to 8, GEM port ID to
11, and user-side VLAN ID to 8. The OLT does not limit inband management service flows.
Therefore, it is recommended that you use default traffic profile 6.
huawei(config)#service-port 1 vlan 8 gpon 0/2/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the management channel between the OLT and the ONU is available.
l On the OLT, run the ping 192.168.50.2 command to check the connectivity between the
OLT and the ONU. The ICMP ECHO-REPLY packet from the ONU should be received.
l On the OLT, you can remote log in to the ONU to perform the configuration.
----End

11.3.4.5 Configuring the Service Channel Between the OLT and the ONU

This topic describes how to configure service channels between an optical line terminal (OLT)
and an optical network unit (ONU) on a gigabit-capable passive optical network (GPON). After
channels for involved service types are configured on an OLT to which an ONU is connected,
packets of the service types from the ONU can be forwarded based on planned VLANs and
policies at Layer 2.
Prerequisites
1.
2.
Issue 01 (2014-04-30)
11.3.1.3 Adding an ONU to an OLT
11.3.1.4 Configuring the Management Channel Between the OLT and the ONU
performed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
is performed.
is
982