Huawei SmartAX MA5603T Configuration Manual page 327

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Figure 3-9 Example network for configuring the H.248-based VoIP service
Prerequisite
l
l
Data Plan
After the service requirements are further confirmed and analyzed with the service provider, the
data plan is made by considering the interconnection with the MGC and according to the data
plan described in Configuring the VoIP Service (H.248-based or MGCP-based).
provides the data plan for configuring the H.248-based VoIP service.
Issue 01 (2014-04-30)
According to the actual network, a route from the MA5600T/MA5603T/MA5608T to the
MGC must be configured to ensure that the MA5600T/MA5603T/MA5608T and the MGC
are reachable from each other.
Electronic switch 0 must be in location-1 (indicating that the system goes upstream through
only the upstream board). Electronic switch 1 must be in location-0 (indicating that the
VoIP service is supported). For details about how to configure the electronic switch, see
electro-switch.
NOTE
l The SCUN and SCUH control boards do not support electronic switch.
l The control board SCUL does not provide the upstream port and the system goes upstream
through only the upstream board.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
Table 3-3
302